Waldorf Q+ Manuel d'utilisateur télécharger pdf (Page 42)

Multi Mode – Instrument settings

43 Waldorf Q User’s Manual

 With this Multimode parameters you can quickly create a live setup with only certain

instruments reacting to controller data. You can also define which instruments transmit Midi

data and which do not.

Engine Play / Mute / Solo

Engine 1

Play

This parameter activates or deactivates an instrument.

• Play will cause the instrument to play normally.

• Mute will mute the selected instrument.

• Solo mutes all other instruments apart from the one chosen.

 The settings for the Engine parameter are also present in the Multi Mixer.

Transpose|Detune 1

+00 | +00

Transpose -48…+48

Transposes the Instrument in semitone steps. I.e., a value of –12 means that the Instrument sounds

one octave lower than it was originally programmed.

Detune -64…+63

Detunes the Instrument in steps of 1/64th of a semitone.

 You can set up nice layer sounds with Transpose and Detune. Activate two Instruments and

set their parameters to identical values including the sound number. Then just transpose one

Instrument by one octave and you got a fat layer sound. Or set them both to the same octave

and set Detune of one Instrument to –05 and the other to +05.

LowVelo |HiVelo 1

001 | 127

Low Velo 001…127

LowVelo allows you to limit the velocity range in which the instrument is played. Only notes

with a velocity higher or equal to the selected value are passed through. Set this parameter

1, if you want to turn velocity switching off.

Hi Velo 001…127

HiVelo is the counterpart to LowVelo. Only notes with a velocity lower or equal to the

selected value are passed through. Set this parameter to 127, if you want to turn velocity

switching off.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 170 171

Pas de commentaire

Waldorf Q+ Manuel d'utilisateur Page 42