Waldorf Q+ Manuel d'utilisateur télécharger pdf (Page 125)

Sound Parameters – Envelopes

Waldorf Q User’s Manual 126

Loop S1S2

The Loop S1S2 envelope type loops the envelope between Sustain 1 and Sustain 2 as long as a note is

held, after it went through the attack phase once. This means, when Sustain 2 is reached, Decay 1 is

used to go to Sustain 1 again, then Decay 2 is used to go to Sustain 2 and so on. As soon as the note

is released, the envelope proceeds with the Release phase. It uses the parameter set of the ADS1DS2R

envelope.

Attack Decay

Sustain

Release

Key pressed Key released

Time

Level

100%

Attack Level

Sustain 2

Decay 2

Loop

Picture 42: Loop S1S2 Envelope

Attack 0…127

Determines the attack rate or amount of time it takes for a signal to go from zero to Attack level.

Attack Level 0…127

Controls the level where the Attack phase ends and the Decay phase starts.

Decay 0…127

Determines the decay rate or amount of time it takes for a signal to reach the Sustain level. This

phase is also used in the loop to go from Sustain 2 to Sustain.

Sustain 0…127

As soon as the Sustain level is reached, the envelope proceeds with the second Decay/Sustain pair

as explained below.

Decay 2 0…127

Determines the decay rate or amount of time it takes for a signal to reach the Sustain 2 level.

Sustain 2 0…127

Sets the second Sustain level. As soon as this level is reached, the loop starts by using the first Decay

rate to go to the first Sustain level.

Release 0…127

Once the note is released, the release phase begins. During this phase, the envelope fades to zero at

the rate determined by the Release value.

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 170 171

Pas de commentaire

Waldorf Q+ Manuel d'utilisateur Page 125