Waldorf Q+ Manuel d'utilisateur télécharger pdf (Page 101)

Sound Parameters – Effects

Waldorf Q User’s Manual 102

Feedback |Polarity

064 |positive

Feedback 0…127

Controls the amount of signal that is routed back into the Delay line. Lower values therefore produce

fewer echoes than higher values.

Polarity positive / negative

Determines if the feedback signal is fed back into the delay line as it is or if it is inverted beforehand.

Cutoff |Auto Pan

064 | On

Cutoff 0…127

Dampens the signal produced by the Delay effect. This filter is routed before the feedback circuitry

meaning that adjacent taps of the Delay will be dampened further. This creates the typical “high

frequency loss” that often happens in natural echoes. A setting of 127 means that the signal isn’t

filtered while lower settings filter the high frequencies of the feedback signal.

Auto Pan Off / On

Controls if the delay produces an automatic panning effect. If Auto Pan is set to Off, the left input

signal is routed into the left delay line and its output signal is fed back into the same delay line. The

same is true for the right signal and the right delay line. If Auto Pan is set to On, the left input signal is

fed into the right delay line and the right signal is fed into the left delay line. The output of the delay

lines are fed back into the opposite delay line. The result is a so-called Ping-Pong delay.

 You can only hear that effect if the left signal input is different from the right signal input.

Overdrive

The Overdrive effect distorts the input signal by amplifying it drastically and clipping the resulting

signal to a certain output level. The difference between this Overdrive effect and the Drive parameter

of the Filter sections is that Drive affects one single voice while this effect type distorts the output sum

of the whole instrument. Therefore, the resulting effect is different as soon as you play more than one

note and you should think about what fits better to a particular sound program. I.e., the Overdrive

effect works great on Organ or E-Piano sounds.

Drive |Post Gain

064 | 064

Drive 0…127

Controls the amount of distortion the effect produces. Low values create no or only slight distortion

while high values create heavier distortion.

Post Gain 0…127

Controls the output level of the distorted signal.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 170 171

Pas de commentaire

Waldorf Q+ Manuel d'utilisateur Page 101