Waldorf Blofeld Manuel d'utilisateur télécharger pdf (Page 77)

Sound Parameter

77 Blofeld User´s Manual

Pat. Reset off / on

When all steps of an arpeggio pattern are played back, the

pattern is repeated from the beginning so that the arpeggio

is looped. With Pattern Reset, you can decide if the

note list is also restarted from the beginning when the

rhythm pattern is reset.

• If off is selected, the note list is not restarted, so

that there is no synchronization between rhythm

and note list. E.g., when you have a pattern where

four steps are set and you play three notes, the

pattern and the note list are repeated differently.

The pattern restarts after the fourth step while the

note list restarts after the third step. The arpeggio

might look like this:

Pattern Step

Note

Pat. Step

Note

Arpeggio with Pattern Reset set to „on“

• If on is selected, the note list will be restarted as

soon as the rhythm pattern is restarted. The same

arpeggio might now look like this (note the two

C1s in sequence):

Pattern Step

Note

Pat. Step

Note

Arpeggio with Pattern Reset set to „Off"

Arpeggiator Step Data Pages

The following Arpeggiator menu pages all behave

similarly. The left display parameter dial sets the Position

of the step that should be changed while the right display

parameter dial changes the value of the selected step. The

Position parameter is similar on each arpeggiator step data

page. Use the Selection dial to select between Step,

Accent, Glide, Timing and Length.

w You can only select the steps that are in the range set

by Pat. Length. E.g., when you have set Pat.

Length to 8, you can’t change a value of step 9 or

above.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 127 128

Pas de commentaire

Waldorf Blofeld Manuel d'utilisateur Page 77