Waldorf Blofeld Manuel d'utilisateur Page 39

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 128
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 38
Sound Parameter
39 Blofeld User´s Manual
modulations while high settings might add a bell
character to the timbre.
Ultra-low settings like 128’ can create very nice
rhythmic changes when used with the ring
modulator. If this is still not low enough, you can
use the Standard Modulation Matrix to apply
MAXIMUM to the respective oscillator pitch with a
negative amount.
Balance F1 64...middle...F2 63
Determines the ratio of the selected Oscillator’s signal that
is sent to the inputs of Filter 1 and Filter 2. If set to F1 64,
the signal is sent to Filter 1 only. Higher values will
increase the amount of signal that feeds Filter 2 and
decrease the amount of signal that feeds Filter 1. If set to
mid, both filters will receive the same signal level. If set to
F2 63, the signal is sent to Filter 2 only.
Pulsewidth 0...127
Sets the pulse width of the Pulse waveform. The value 0 is
equivalent to a pulse ratio of <1%, the value 127 is
equivalent to 50%. You determine the start point of a
wavetable with the Pulsewidth knob, at which 0 selects
the first of up to 128 Waveforms. If you select any
waveform other than Pulse or the wavetables, this
parameter does not have any effect. The following picture
illustrates the effect of the pulsewidth parameter:
A pulse width of 50% can be used for flute sounds
or very hollow bass sounds.
A pulse width of around 30% can be used for e-
piano or fat bass sounds.
A pulse width of around 10% is interesting for
Clavinet sounds.
Experiment with different start points for the
Wavetable waveforms to get an overview of the
array of available Waveforms for both wavetables.
PWM Source see table „Modulation Sources
Selects the source of the pulsewidth modulation or the
wavetable modulation. Common sources for pulsewidth
modulation are envelopes and LFOs, but other sources
!"#$%&'()*+&,-.
/01"23%4
!"#$%&'()*+&55. !"#$%&'()*+&6,. !"#$%&'()*+&78.
/9:;"#$%4
Vue de la page 38
1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 127 128

Commentaires sur ces manuels

Pas de commentaire