Waldorf Pulse Manuel d'utilisateur télécharger pdf (Page 45)

User’s Manual Pulse • PulsePlus

10.1 Arpeggiator Synchronization via MIDI Clock

The Pulse's Arpeggiator can be used as a master as well as a slave via the MIDI Clock:

• When you use the Arpeggiator as the master, set its speed via the "Tempo"

parameter. The "Global MIDI Channel" parameter must then be set to a value

within the range of A.01...A.16 or A.on. The Pulse will send the Arpeggiator notes

and the MIDI Clock signal via MIDI Out.

• When you use the Arpeggiator as a slave, an external device (e.g. sequencer)

determines the tempo of the Arpeggiator. Set the "Tempo" parameter to "Mid" as

described above. Here too notes and MIDI Clock information can be activated to

control other devices. In this mode, the MIDI Song Position Pointer is also

recognized.

10.2 The Hold Mode

If you set the Active parameter to Hld, the Arpeggiator is in Hold mode. This means that the

incoming MIDI chords generate continuous arpeggios. The Pulse will continue to do so

until you play a new chord or set the parameter back to Off or On. You can also stop the

arpeggiator by performing the panic function or sending an All Notes Off message from

your sequencer.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 77 78

Pas de commentaire

Waldorf Pulse Manuel d'utilisateur Page 45