The Waldorf Pulse™ synthesizer
The Waldorf Pulse™ is a rack mountable, monophonic analog synthesizer built in Germany.
It sports three oscillators, two with pulse width, two LFOs, two assignable envelopes, a filter
and amp section and an advanced arpeggiator. There is also a matrix of four modulation
routings that are assignable by source and destination. This in part, is what gives the Pulse a
unique sound characteristic. Later came the Waldorf Pulse Plus™, the same great synth, but
fitted with the added capability of utilizing MIDI CV control and the ability to route external
signals through the Pulse’s filter and amp sections.
Installation
Unzip the package and place the file in your VST Plug-Ins folder:
Windows XP, Vista
This folder is typically located under your 'Program Files/Steinberg/Vst Plugins' folder.
Mac OSX
This folder is typically located under the 'user/Library/Audio/Plug-Ins/VST' folder.
Setup
Assumptions
It is assumed that the user is familiar with the basic functionalities of the hardware synthesizer,
it's operators manual and the basic concept of MIDI itself. Without this knowledge, utilizing the
editor may be a bit more challenging to set up and use properly. By familiarizing yourself with
the operators manual and the MIDI standards, and following the instructions in this manual, you
should be able to get up and running in a short amount of time.
STEP 1: Setting Up the Pulse
Make sure you have your midi ports and channels set up and matching properly and that all
cables are working and connected properly.
STEP 2: Setting Up the Plugin for Your VST Host (DAW)
The setup procedure will vary from host. Each host may support VST's differently and more
importantly, each host may support MIDI data from a VSTi differently, or not at all. Please refer
to the 'Supported Hosts' list on the rekon audio web site at www.rekonaudio.com. Also, please
refer to the setup instructions provided with your VST host application for setting up a VST
instrument (VSTi).
Setup Example for Cubase SX 1-3
To setup the reKon™ VST Little Phatty Editor for Cubase SX 1-3 or Cubase 4.1.3 **:
1. Be sure to check your VST Instrument plugins folder to make sure the editor was installed.
2. Open Cubase SX or Cubase 4.1.3+.
3. Create a new project.
4. Open your 'VST Instruments' panel and then select the 'reKon™ VST Little Phatty Editor' VST
in
a VST slot.
5. Create a 'MIDI' track. Select this MIDI track. (this will be the MIDI track the VST Little Phatty
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels