Waldorf pulse 2 Manuel d'utilisateur télécharger pdf (Page 27)

Sound Parameter

27 Pulse 2 User Manual

Sustain 0...127

Determines the sustain level which is held until a note

ends.

Release 0...127

Once the note has ended, the release phase begins.

During this phase, the envelope fades to zero at the rate

determined by the Release value.

Loop OFF / A-D / D-D

The Loop mode can be used to use an envelope as an

additional LFO. The following settings can be used:

• OFF creates no loop.

• A-D loops attack and decay phases without reset-

ting to 0 until the release phase starts.

• D-D lets alternate the envelope from full scale to

zero to full. Sustain controls the speed.

Trigger SNG1 / SNG2/ RET 1 / RET 2 / RET 3

Five different types of triggers determine how and when

an envelope is started.

• With the setting of SNG 1, the first note starts the

envelope. All other notes do not restart while a

note is sustained. The release phase is not started

until all keys are released. SNG 2 works in the

same way, except that the envelope is started at

the current value rather than reset to zero at

every new start.

• With the setting of RET 1, the envelope is

restarted with every incoming note. With RET 2,

the envelope is restarted with every incoming

note, but is not reset to zero. Finally, RET 3 trig-

gers the envelope with every note on. While

holding the note, the envelope is not restarted

and won´t be retriggered when a note is relea-

sed.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 72 73

Pas de commentaire

Waldorf pulse 2 Manuel d'utilisateur Page 27